Experience service like never before when purchasing the System Sensor P2R. Call our experts today! Quick & Reliable Shipping, Hassle Free. Free Shipping. Buy SYSTEM SENSOR P2R Horn Strobe, Wall, 2-Wire, Std Candela, Red at The SpectrAlert Advance P2R is a red, two-wire horn strobe with selectable strobe settings of 15, 15/75, 30, 75, 95, and cd.
|Published:||24 June 2014|
|PDF File Size:||25.74 Mb|
|ePub File Size:||11.84 Mb|
Then, connect the notification appliance p2r system sensor wiring to the SEMS terminals on the mounting plate. The System Sensor P2R will rotate into position, locking the product's pins into the mounting plate's terminals.
System Sensor P2R | Fire Alarm Horn Strobe | HomeSecurityStore
The System Sensor P2R fire alarm horn strobe will temporarily hold in place with a catch until it is secured with a captured mounting screw. The wall mount watertight junction box must be mounted with its internal post in p2r system sensor lower left corner as shown in Figure 8.
P2r system sensor field wiring according to terminal definitions. If the product is not to be installed at this point, use the dust cover to prevent contamination of the wiring terminals of the mounting plate. To attach product to mounting plate, hook tabs on the product housing into the grooves on mounting plate.
Search [ P2R ] / System Sensor - System Sensor
Then, swing product into position to engage the pins on the product with the terminals on the mounting plate. Make sure that the tabs on the back of the product housing fully engage with the mounting plate.
Secure product by tightening p2r system sensor single mounting screw in the front of the product housing.
Standard captured mounting screw may be replaced with enclosed torx screw for tamper resistance. A Mounting Wall or Ceiling 1.
System Sensor Fire Alarm Horn Strobe Red
Attach mounting plate to junction box as shown in Figure 6. If using a back box skirt, attach the mounting plate to p2r system sensor skirt and then attach the entire assembly to the junction box see Figure 7.
The electronic visual warning signal uses an extremely reliable xenon flash tube. It flashes at least once every second.
The strobe must not be installed in direct sunlight or p2r system sensor of high light intensity over 60 foot candles where the visual flash might be disregarded or not seen. The strobe may not be seen by the visually impaired. The signal strobe may cause seizures. Individuals who have positive photoic response to visual stimuli with seizures, such as persons with epilepsy, should avoid prolonged exposure to environments in which strobe signals, including this strobe, are activated.
SYSTEM SENSOR P2R HORN STROBE 2W STD CD RED – RYBB Fire Alarm Parts, Service, & Repairs
The signal strobe cannot operate from coded power supplies. Coded power supplies produce interrupted power. The strobe must have an uninterrupted source of power in order to operate correctly.
System Sensor recommends that the horn and signal strobe always be used p2r system sensor combination so that the risks from any of the above limitations are minimized.
2WIRE HORN/ STROBE STD RED
The horn may not be heard. Then, connect the notification appliance circuit wiring to the SEMS terminals on the mounting plate. The System Sensor P2R will rotate into position, locking the product's pins into p2r system sensor mounting plate's terminals. The System Sensor P2r system sensor fire alarm horn strobe will temporarily hold in place with a catch until it is secured with a captured mounting screw.